Thank you for purchasing a Stately Caverns Displayset and waiting patiently for so long. I hope it's been worth the wait! Download Dida Displays Basic Box Instructions PDF.
Here are all the parts...
Start with the bottom Level: Attach the open wall first by laying it flat on the ground.
Add the main wall and then fold the box into shape.
You can usually
press the remaining snaps together by pushing on both sides. It may be neccessary
to set the box on it's side to push the snaps down. Be patient--it's a tight
fit.
Find the 6 inch piece of plastic track and use it to grip the bottom strut
of the opening to the floor tab.
Computer Level: Lay the second level down flat and attach the consoles by
pushing with your thumb on the inside of the console. You may have to flex
or arch the back of the console a bit to get them to fit.
Complete the box (this shot shows setting the box on it's side and pressing down).
Mansion Level: If the skyline signal is not already affixed, remove the backing
and center it within the window and smooth down.
Assemble the sliding door wall as you did the Bottom level.
Tower shaft: Push the black plastic end of the poles into the triangle holes
(the holes without the rubber gaskets). Make sure you push with the shiny
side facing you. Only push the plastic part halfway through so it grips the
triangle--DO NOT PUSH IT ALL THE WAY THROUGH.
Snap the triangle to the bottom of the tower.
Attach tower tabs to snaps on the back of the bottom level door opening.
Use the opening to get access to the snaps.
Set one gray ledge panel on top of the bottom level and then snap the Computer
level to the tower tabs..
Push from the top to get access to the snaps.
Slide Quick Change box onto poles.
Put top triangle into place, shiny side down, and thread cord through the
small top and side holes.
Push rubber gaskets onto poles to hold them in place.
Snap top tower flanges to sliding door wall.
Use opening to gain access to snaps.
Slide plastic support track over all three layers of material (roof, floor
and ledge panel).
Wedge 2 black cardboard strips into the underside plastic track to insure a firm grip.
Insert sliding bookcase panel.
Use clip at bottom of tower to hold cord in place when Quick change box is raised.